Paxton Net2 nano control unit Manuel d'utilisateur télécharger pdf

Page 1

redaeR

:n oitu

C yl

nos

redaerC D V21roF

12V

Red LED

Amber LED

Green LED

Data/D0

Clock/D1

Media Detect

Entry

12V

12V Lock

N.C.

N.O.

COM

Alarm

12V

Green LED

Exit

Contact

Tamper

PSU

nott

u Btix

yaleR

kcoL

stuptuO

stupnI

rewoP

tcatnoC

repmaT/USP

Net2 nano

http://paxton.info/107

123456

0889

12345126

Ins-30075 Net2 nano control unit

Exit button

(push to make)

Reader/keypad

Tamper switch

(optional)

Door contact switch

(held closed by door)

18/04/2013

Technical Support

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

01273 811011

[email protected]

12V DC

power supply

This is the heartbeat of the

system and should pulse

regularly. This indicates that

the processor is functioning.

Net2Air wireless activity (Tx/Rx) - Blue

12V (Green) - Power LED

Lock (Orange) - The 12V lock output is energised

Relay (Orange) - The relay is energised - (N.O./COM contacts are closed)

Alarm (Red) - 12V Alarm output is active

Exit (Orange) - The exit button contacts are closed

Contact (Orange) - The door contacts are closed

Tamper (Orange) - The tamper contacts are closed

PSU (Orange) - The PSU contacts are closed

Net2Air (Blue) - Net2Air interface Tx/Rx activity

OK (Green ash) - The internal software is running

LED indications

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Diagnostic LED's

This wireless unit requires a Net2Air bridge to communicate with the server PC.

Not connected

Lock release

A new unit requires approximately 30 seconds after initial power up to self congure.

During this time the OK LED will not be ashing.

The unit will not operate correctly until this function has completed.

Paxton

1 2 3 4 5

Résumé du contenu

Page 1 - 01273 811011

Page 1redaeR:n oitua C ylnosredaerC D V21roF12VRed LED Amber LED Green LED Data/D0Clock/D1Media Detect 0VEntry12V12V Lock 0V0VN.C.N.O. COMAlarm12VGree

Page 2 - Radio frequency

Page 2Control unit installationWire the components to the Access Control Unit (ACU) as shown on the rst page. This will include: - Re

Page 3 - INPUT / OUTPUT WIRING

Page 3The Net2 software should be loaded on the controlling PC and at least one Net2Air bridge congured to communicate with the unit.Software install

Page 4 - Net2 nano reset

Page 4A Nano must bind to a Net2Air bridge before it will enrol itself onto the Net2 system. The term 'bind' is used to denote the xed rela

Page 5 - Specications

Page 51 - ACU fails to enrol onto the PC (WIRELESS PROBLEMS).QThe Net2 nano must be in range of a Net2Air bridge. Detailed advice can be found on the